1. Two cabinet securing brackets are supplied with4. If necessary, pads are supplied for the rear feet to
the installation pack. They need to be assembledmake sliding the appliance in and out of the recess
onto the cabinet prior to cabinet being pushed intoeasier. To fit the pads, press them onto the rear
the Kitchen aperture.feet.
- To fit these brackets remove the two screws at theIf required, the dimensions of these pads can be
top left and right hand front corners of the cabinet.reduced by breaking them where marked.
- Position the two brackets as shown in the figure
and replace the two securing screws.
E
Left handRight hand
bracketbracket5. The joint cover (B) is to be assembled after having
installed the appliance in the recess.
2. Push the appliance into place. The plug socket10
necessary for connection of the appliance to the
electricity supply should be positioned, so that the
plug is not placed in the recess.13
6
9
7
12
8
11
3
2
3. To adjust the height proceed as follows:
- Loosen or tighten the two front feet.
- The rear feet are adjusted by turning the screw in
the front kick plate to the left or right.
596
115°
555
max
4
-
+
Li89
23 |
ACEC
